Simpson Strong-Tie CPS7 – 8-inch x 8-inch Standoff Base

Description

Simpson Strong-Tie CPS7 – 8-inch x 8-inch Standoff Base

Installation

Post:

• Drill a 3/4″-diameter hole, 10″ into the center of the post.
• Clean out dust. Fill hole halfway with Simpson Strong-Tie^® SET-3G^™ epoxy anchoring adhesive.
• Insert all-thread rod and allow epoxy to set and cure.
• Secure standoff to post using four 0.148″ x 3″ nails, except PBV which uses four Strong-Drive^® SDS Heavy-Duty Connector screws.

Concrete:

• Drill a 3/4″-diameter hole per anchor design (see table footnote 2).
• Clean out dust. Fill hole halfway with Simpson Strong-Tie SET-3G epoxy anchoring adhesive. Insert post subassembly into hole and allow epoxy to set and cure.
• Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non-top-supported installations (such as fences or unbraced carports).

Material

• CPS — engineered composite polymer